Ground Controls - JLG TOUCAN 10E Service And Maintenance Manual

SECTION 10 - DIAGNOSTIC TROUBLE CODES
DTC FAULT MESSAGE
LIFT ENABLE SWITCH PER-
2241
MANENTLY SELECTED
FUNCTION LOCKED OUT -
2242
MAST JOYSTICK NOT CEN-
TERED
FUNCTION LOCKED OUT - JIB
2243
JOYSTICK NOT CENTERED
GATE LIMIT SWITCH - FAULTY
2244

2-3 Ground Controls

DTC FAULT MESSAGE
FUNCTION PROBLEM -
233
BRAKE RELEASE PERMA-
NENTLY SELECTED
FUNCTION PROBLEM -
2310
GROUND ENABLE PERMA-
NENTLY SELECTED
FUNCTION PROBLEM - MAST
2368
LIFT UP PERMANENTLY
SELECTED
FUNCTION PROBLEM - MAST
2369
LIFT DOWN PERMANENTLY
SELECTED
10-4
DESCRIPTION
The Lift Enable Switch was closed during
power-up in platform mode.
The Mast Joystick was not centered at
power-up in platform mode.
The Jib Joystick was not centered at
power-up in platform mode.
This DTC does not apply to the Toucan
10E.
DESCRIPTION
The Brake Release switch was closed
during power-up in ground mode.
The Ground Enable switch was closed
during power-up in ground mode.
The Mast Lift Up switch was closed during
power-up in ground mode.
The Mast Lift Down switch was closed
during power-up in ground mode.
– JLG Lift –
CHECK
• Check if the lift enable switch is obstructed or
jammed.
• Check lift enable switch output voltage : J1(18).
• Release joystick and allow to center.
• Check if the joystick is obstructed or jammed.
• Proceed with a calibration.
• Check the joystick voltages : if the power is not cor-
rect, replace the board; if the output is not correct,
replace the joystick (refer to Section 8).
• Release joystick and allow to center.
• Check if the joystick is obstructed or jammed.
• Proceed with a calibration.
• Check the joystick voltages : if the power is not cor-
rect, replace the board; if the output is not correct,
replace the joystick (refer to Section 8).
CHECK
• Check if the concerned switch is damaged,
obstructed or jammed.
• Disconnect the membrane panel ribbon cable :
replace the membrane panel if DTC is no longer
present.
• Check the switch line voltage : J3(12), CR1(34) and
CR2(17).
• Check if the concerned switch is damaged,
obstructed or jammed.
• Disconnect the membrane panel ribbon cable :
replace the membrane panel if DTC is no longer
present.
• Check the switch line voltage : J3(4), CR1(9) and
CR3(19).
• Check if the concerned switch is damaged,
obstructed or jammed.
• Disconnect the membrane panel ribbon cable :
replace the membrane panel if DTC is no longer
present.
• Check the switch line voltage : J3(6), CR1(21) and
CR3(20).
• Check if the concerned switch is damaged,
obstructed or jammed.
• Disconnect the membrane panel ribbon cable :
replace the membrane panel if DTC is no longer
present.
• Check the switch line voltage : J3(7), CR1(22) and
CR3(32).
31210090