Section 6 - Jib And Platform; Platform; Platform Removal; Platform Installation - JLG TOUCAN 10E Service And Maintenance Manual

6.1 PLATFORM

Platform Removal

1. Place the machine on a flat and level surface. From
ground controls, swing the turntable 90° from chas-
sis center line and raise slightly the jib. Shut
machine down.
2. Attach slings to the platform railings. Using an over-
head crane or another suitable lifting equipment,
draw all slack from slings.
Figure 6-1. Platform Removal-Installation
3. Remove clamp securing electric cables to the plat-
form. If fitted: disconnect AC socket. If fitted: remove
clamp securing the air line.
4. Remove platform connectors casing cover (1). Dis-
connect the connector from the platform console.
5. Remove both side bearings covers (2).
6. Remove one screw (3) from each bearing pin (4).
Remove the bearing pins (4). Remove the ball bear-
ings (5).
7. Lift and remove the platform assembly (6).
8. Check the ball bearings (Qty:6) for cracks or hard
points. Replace bearings if necessary.
31210090
SECTION 6. JIB AND PLATFORM

6.2 OVERLAOD SYSTEM

– JLG Lift –

SECTION 6 - JIB AND PLATFORM

Platform Installation

1. If removed, install ball bearings (5) on platform sup-
port front pins (7) and secure with hardware (Use
Loctite®243).
2. If removed, install the 16 bevel washers (8) on plat-
form support top pin.
3. Install platform onto its support. Install side ball
bearings and pins. Secure with hardware (Use Loc-
tite®243).
4. Install side bearings covers.
5. Correctly route cables (and air hose if fitted) on plat-
form and install clamp(s). Attach cables to platform
channel (9) with plastic straps. Insert harness con-
nectors in their casing and install casing cover (1).
Plug the connector to platform console. (Connect
AC line to socket if fitted).
6. Set overload system: Refer to Section 8-2.

Bevel Washers Lubrication

Bevel washer piling up lubrication is important to maintain
overload system accuracy. Coat the spring washers using
a brush or by spaying.
Lube Points - Spring Washers
Capacity: A/R
Lube - D (See Table 1-14)
Interval - Every 125 hours of operation or after each clean-
ing
Figure 6-2. Bevel Washer Lubrication
6-1