Lubrication Chart; Lubrication Intervals For Various Components - JLG 10VP Service And Maintenance Manual

ITEM COMPONTENT
Fill To Line on
1 Hydraulic Oil Reservoir
5 Qt. Reservoir
Drive Wheel
2 4 - Grease Fittings MPG- Pressure Gun
Bearings
Drive Wheel
3 2 - Gear Box
Gear Box
4 Caster Axles 2 - Grease Fitting
5 Swivel Raceways 2 - Front Casters
6 Mast Chains * 2 - Per Section
* Applies Only to Mast Sections with Chains.
Key to Lubricants: MPG - Multipurpose Grease
HO - Hydraulic Oil - See Section 1.5, "Lubrication" in Service Manual.
GEAR OIL - Good Quality Worm Gear Oil - SAE 90 - AGMA#5 - EP Compounded
Notes: 1. Be certain to lubricate like items on each side of the machine.
2. Recommended lubricating intervals are based on normal use. If machine is subjected to severe operating conditions,
such as a high number of cycles, location, corrosive/dirty environment, etc., user must adjust lubricating requirements accordingly.
3. Prior to checking hydraulic oil level, operate machine through one complete cycle of lift function (full up and down). Failure to do so will
result in incorrect oil level reading on the hydraulic reservoir.
3120728
6
1
2
3
Figure 1-4. Lubrication Chart.
Table 1-6.Lubrication Intervals for Various Components
NO/TYPE
LUBE/METHOD
LUBE POINTS
HO - Check Hyd. Oil
Level
HO - Change Hyd. Oil
Gear Oil
MPG - Pressure Gun
MPG - Pressure Gun
Chain Lube - Brush or
Spray
INTERVAL HOURS
3 6 1
MONTHS MONTHS YEAR
150 Hrs. 300 Hrs. 600 Hrs.
✔
✔
✔
✔
– JLG Lift –
SECTION 1 - SPECIFICATIONS
4, 5
2
COMMENTS
YEARS
1200 Hrs.
Check Hydraulic Oil every 10 hrs.
Change Hydraulic Oil every 1200
✔
hrs.
Change only when serviced
requires 6 oz. (175 cc's) to fill.
Inspect, lubricate if dry or rusting.
1-5