Installer Instructions; Accessing The Installer Level; Configuring The Installation At Installer Level - DeDietrich C 340 Series Installation And User Manual

9

Installer instructions

9.1

Accessing the installer level

Fig.82 Installer level
00:12 ........ ....... ........ ......... ...
..... ... ....... .... .. ..... ....... .... ..... .......
i
........ .......
0
0 0 1
1 1 2
2 2 3
3 3 4
4 4 5
9.2

Configuring the installation at installer level

Tab.63 CU-GH13
Icon Zone or function
Internal DHW (Internal DHW)
CIRCA / CH
Auto filling CH
Commercial boiler
Gas fired appliance
Shower time function
Tab.64 SCB-10
Icon Zone or function
CIRCA 1
CIRCB 1
DHW 1
CIRCC 1
Outdoor temperature
0-10 volt input
Analogue input
Cascade management B
Digital Input
Passive buffer tank
Status information
7762666 - v.02 - 29092020
0
1
2
3
4
5
6
AD-3001378-02
Description
Domestic hot water produced by boiler
Central heating circuit
Adjust or start the automatic filling unit
Gas boiler
Gas boiler
Activate the shower time function
Description
Central heating circuit A
Central heating circuit B
Domestic hot water external circuit
Central heating circuit C
Outdoor sensor
0–10 volt input signal
Analogue input signal
Management of a cascade of multiple boilers
Digital input signal
Enable a buffer tank with one or two sensors
PCB SCB-10 status information
Some parameters that may affect the operation of the boiler are protected
by an access code. Only the installer is allowed to modify these
parameters.
1. Select the tile [ ].
2. Press the button to confirm the selection.
3. Use the rotary knob to select code: 0012.
4. Press the button to confirm the selection.
When the installer level is enabled, the status of the tile [
changes from Off into On.
5. To leave the installer level, select the tile [
6. Use the rotary knob to select Confirm or Cancel.
7. Press the button to confirm the selection.
When the installer level is disabled, the status of the tile [
changes from On into Off.
When the control panel is not used for 30 minutes, the installer level is left
automatically.
Configure the installation by pressing the
Installation Setup . Select the control unit or circuit board you want to
configure:
9 Installer instructions
]
] .
]
button and selecting
C 340 / C 640 73