Turning A Parameter On Or Off - Infors HT Multitron Operating Manual

7.4.3

Turning a Parameter On or Off

Procedure
20 August 2020
Turning a parameter on
To turn a parameter on, proceed as follows:
INFORMATION
Steps 1 and 2 can be omitted, if the parameter is turned on di-
rectly after entering the setpoint value.
1. Select the desired pair of parameters with the Select key (1).
OFF
The message indicates, that the parameter is switched off.
2. Tap the SET key (2) in the upper or the lower setting key area,
depending on which parameter should be switched on.
On the alphanumeric display the setpoint value of the parameter
is shown. The sign
switched on.
3. To switch on the parameter, tap the ON/OFF key (3) in the ac-
cording operating key area.
The parameter is instantly turned on.
Setpoint
The sign disappears. On the alphanumeric display the
message on appears for a very short time, then the current value
of the parameter is shown.
INFORMATION
rotation speed
When the parameter
table starts to move instantly. It is therefore suggested to turn it on
last.
Multitron - Operating Manual
1
Setpoint
indicates, that the parameter can be
RPM
( ) is activated, the shaker
Operation
2
3
Page 93 of 158