Setting The Parameter Setpoints - Infors HT Multitron Operating Manual

Multitron - Operating Manual
Operation
7.4.2

Setting the Parameter Setpoints

Procedure
Page 92 of 158
To set the parameter setpoints, proceed as follows:
1. Select the desired pair of parameters with the Select key (1).
The alphanumeric display field shows the current values of the
selected parameter pair.
2. To activate programming, tap the SET key (2) in the upper or
the lower setting key area, depending on which parameter set-
point should be set.
The alphanumeric display field shows last set setpoint of the pa-
Setpoint
rameter. The
can be set.
INFORMATION
Setpoint
The sign lights up for 10 seconds. If you do not make an
entry in that time, you have to tap the SET key again.
3. Use the Plus or Minus key (3) to set the desired setpoint of the
selected parameter.
After approx. 10 seconds the
new setpoint is saved. You can speed up this process by tapping
the Select key.
INFORMATION
The entered value is saved automatically. A separate confirmation
is not necessary. If the parameter is already activated, the changes
take effect immediately.
1 2 3
sign indicates, that the parameter setpoint
Setpoint sign disappears and the
20 August 2020