82
Chapter 7—Other DME Designer Functions
Changing the Size of Rotary Controls & Sliders
The size of individual rotary controls and sliders can be changed as follows.
Open the control window as normal.
1
The control window opens.
Select the rotary control or slider.
2
The rotary control or slider appears highlighted.
While holding down the Shift key, right-click over the control.
3
The following pop-up menu appears.
Choose Control Size.
4
The Control Size window appears, as shown below.
Select a size and then click OK to save your settings, or click Cancel to leave
5
them unchanged.
The Properties window closes and the control appears at the selected size.
Examples of large and small rotary controls and sliders are shown below.
DME32—Owner's Manual