Yamaha DME32 Owner's Manual page 172

LPF
An LPF (low-pass filter) attenuates signals above the specified frequency while allowing
signals below that frequency to pass through unaffected.
The LPF component features one input and one output.
The LPF control window features INPUT, filter, and OUTPUT sections.
The LPF component parameters are explained in the following table.
Section Parameter
ON/OFF ON/OFF
LEVEL –Infinity dB to 0.0 dB
INPUT
PHASE NOR/REV
FREQ 20.0 Hz–20.0 kHz
Filter
–6 dB/octave,
SLOPE
–12 dB/octave
OUTPUT LEVEL –Infinity dB to 0.0 dB
MUTE ON/OFF
Range
Turns the component on and off
Adjusts the input signal level
Inverts the input signal
Adjusts the LPF cutoff frequency
Selects the filter slope
Adjusts the output signal level
Mutes the output
167
Filter
Description
DME32—Owner's Manual