Checking The Driver Is Installed Correctly; Usb Operating Notes - Yamaha DME32 Owner's Manual

14
Chapter 2—Getting Started
In the Browse for Folder window, select the "USBdrv_" folder on the DME32
8
CD-ROM, and then click OK.
9 Click Next.
The next window tells you that Windows has detected the driver and is now ready to install
it. Make sure that the device is stated as "YAMAHA USB MIDI Driver."
Click Next.
10
Windows installs the driver.
When the installation is complete, the "Windows has finished..." window appears.
11 Click Finish.
Installation is complete.

Checking the Driver is Installed Correctly

Follow the steps below to make
sure that the driver has been
installed correctly.
Right-click the My Computer
1
icon and choose Properties.
The System Properties window
appears.
Click the Device Manager tab.
2
The device list appears.
3 Check to see if "YAMAHA USB
MIDI Driver" appears in the
list, as shown right. If it does,
the driver is installed correctly.
Click Cancel to close the Prop-
4
erties window.

USB Operating Notes

If you turn on or off the power to the DME32, or connect or disconnect the USB cable under
the following conditions, your computer may freeze, or some of the DME32 functions may
be disabled:
• While the DME32 is being detected by Windows or its driver is being loaded.
• While Windows is starting or shutting down.
• When your computer is in standby mode.
• While an audio or MIDI program is starting.
In addition, the following may cause your computer to freeze or disable some DME32 func-
tions:
• Turning the power on or off, or repeatedly connecting and disconnecting the USB
cable.
• Entering or leaving standby mode during an audio or MIDI data transfer.
• Connecting or disconnecting the USB cable while the DME32 is turned on.
• Turning the power to the DME32 on or off, starting your computer, or installing the
driver while a large amount of data is being transferred.
If you cannot shutdown Windows, try disconnecting the USB cable from the DME32.
If you cannot start Windows, turn off your computer, disconnect the USB cable, turn your
computer on again, and then reconnect the USB cable.
DME32—Owner's Manual