Yamaha DME32 Owner's Manual page 211

206
Chapter 10—Front Panel Operation
Temporarily Disabling the Protection System
The protection system can be temporarily disabled to allow editing by authorized users.
Press the [PROTECT] button.
1
The Enter password display appears, as shown below.
Use the SCENE RECALL number keypad to enter the password.
2
An asterisk appears as each number is entered, as shown below.
Press the [RECALL] button.
3
If the correct password is entered, the protection is disabled and the PROTECT indica-
tor goes out. If the password is incorrect, the Change password display appears. Press
the [VALUE] button to cancel this display.
While the protection system is temporarily disabled, scenes can be stored and recalled
and parameters can be edited as normal.
To turn the protection system back on again, press the [PROTECT] button.
4
The Shift to Protect Mode display appears, as shown below.
Press the [VALUE] button to enable Full Protect mode, or press the [PARAM-
5
ETER] button to cancel.
Full Protect mode is enabled and the PROTECT indicator lights up.
If you forget the password, see "Checking the Firmware Version & Battery" on page 210.
DME32—Owner's Manual
SCENE NO.
0 i
SCENE NO.
0 i
SCENE NO.
0 i
CONFIGURATION
CONFIGURATION
CONFIGURATION
SCENE
SCENE
SCENE