Yamaha DME32 Owner's Manual page 197

192
Chapter 9—Component Guide Part II
Choose Paste.
7
The copied parameter appears on the control window, as shown below.
Drag the parameter by its border to position it within the control window.
Repeat steps 3 to 7 to copy other parameters to the User Control window.
8
To delete a control, select it, then while holding down the Shift key, right-click
9
over the control.
The following pop-up menu appears.
Choose Delete to delete the selected control, or select All Delete to delete all
10
controls.
The selected control, or all controls are deleted.
User controls are stored in configurations, and once completed, it's a good idea to store
the configuration. You must compile and transfer the configuration to the DME32 for
the user control to take effect.
When a parameter on the User Control is adjusted, the corresponding parameter on the
source component is also adjusted and vice versa. If both parameter controls are visible
on-screen, you can see both of them move as either control is adjusted.
Parameters on a User Control control window can be adjusted even when the source
component is password protected. See "Using Password Protection" on page 83 for
more information. Components can be protected individually using the Protect option
on the Properties window. See "Customizing Component Properties" on page 80 for
more information.
DME32—Owner's Manual