Yamaha DME32 Owner's Manual page 274

272
Appendix A: General
Message
The DME32 configuration
data has changed. Receive
data from DME32?
This component is
protected!
This operation is
protected!
Too many components for
DME32 #!
You must enter a title for
the configuration!
You must enter a title for
the user module!
Available resources are
low. Further editing is not
recommended. Delete
some components or
restart the program to
resolve the problem.
DME32—Owner's Manual
Reason
The configuration data has changed on
the DME32. This may due, for example,
to the wordclock setting being changed
from the front panel, or a configuration
being loaded from a PC Card.
An attempt was made to edit a pro-
tected component.
An attempt was made to use a pro-
tected operation.
The maximum number of components
for the specified DME32 has been
exceeded.
An attempt was made to send a config-
uration, but no configuration was
selected, or no title was entered.
An attempt was made to save a user
module, but no title was entered.
This message warns that Windows
resources are getting low, perhaps
because there are many configuration
windows open, or several programs are
running simultaneously. If you continue
using DME Manager, Windows may
suddenly quit DME Manager.
Solution
Click OK to receive the updated config-
uration data from the DME32.
Turn off the component's protection,
and then try editing again.
Turn off the Operation or Component
protection, and then try again.
Delete any unused components in order
to free up resources, and then add the
new component.
Select a configuration, or enter a title,
and then try sending again.
Enter a title, and then try saving again.
Close some configuration windows, quit
some other programs, or restart DME
Manager.