Yamaha DME32 Owner's Manual page 106

100
Chapter 8—Component Guide Part I
Section Parameter
Level
INPUT
MUTE
GAIN
MUTE
PHASE
LOW
FREQ
1
LPF Gc
SLOPE & TYPE
FREQ
1
HPF Gc
SLOPE & TYPE
GAIN
LOW-MID MUTE
PHASE
FREQ
1
LPF Gc
SLOPE & TYPE
FREQ
1
HPF Gc
SLOPE & TYPE
GAIN
HIGH-MID MUTE
PHASE
FREQ
1
LPF Gc
SLOPE & TYPE
GAIN
MUTE
PHASE
HIGH
FREQ
1
HPF Gc
SLOPE & TYPE
1. Gc controls appears only when a Gc SLOPE & TYPE filter is selected. For Butterworth, Bessel, and Link-
witz-Riley, the Gc setting is ignored and the Gc value is fixed as follows: Butterworth and Bessel: –3 dB, Link-
witz-Riley: –6 dB.
2. SLOPE & TYPE parameter values are listed in the following table.
DME32—Owner's Manual
Range
–Infinity dB to 0.0 dB Adjusts the input signal level
ON/OFF Mutes the input
–Infinity dB to 0.0 dB Adjusts the LOW output signal level
ON/OFF Mutes the LOW output
NOR/REV Inverts the LOW output signal
20.0 Hz–20.0 kHz Adjusts the LOW LPF cutoff frequency
–6 dB to +6 dB Adjusts the LOW LPF gain at the cutoff frequency
2
Sets the LOW LPF filter slope and type
20.0 Hz–20.0 kHz Adjusts the LOW-MID HPF cutoff frequency
–6 dB to +6 dB Adjusts the LOW-MID HPF gain at the cutoff frequency
2
Sets the LOW-MID HPF filter slope and type
–Infinity dB to 0.0 dB Adjusts the LOW-MID output signal level
ON/OFF Mutes the LOW-MID output
NOR/REV Inverts the LOW-MID output signal
20.0 Hz–20.0 kHz Adjusts the LOW-MID LPF cutoff frequency
–6 dB to +6 dB Adjusts the LOW-MID LPF gain at the cutoff frequency
2
Sets the LOW-MID LPF filter slope and type
20.0 Hz–20.0 kHz Adjusts the HIGH-MID HPF cutoff frequency
–6 dB to +6 dB Adjusts the HIGH-MID HPF gain at the cutoff frequency
2
Sets the HIGH-MID HPF filter slope and type
–Infinity dB to 0.0 dB Adjusts the HIGH-MID output signal level
ON/OFF Mutes the HIGH-MID output
NOR/REV Inverts the HIGH-MID output signal
20.0 Hz–20.0 kHz Adjusts the HIGH-MID LPF cutoff frequency
–6 dB to +6 dB Adjusts the HIGH-MID LPF gain at the cutoff frequency
2
Sets the HIGH-MID LPF filter slope and type
–Infinity dB to 0.0 dB Adjusts the HIGH output signal level
ON/OFF Mutes the HIGH output
NOR/REV Inverts the HIGH output signal
20.0 Hz–20.0 kHz Adjusts the HIGH HPF cutoff frequency
–6 dB to +6 dB Adjusts the HIGH HPF gain at the cutoff frequency
2
Sets the HIGH HPF filter slope and type
Description