Using Data Logger Mode; Waveform Recording - Keysight Technologies CX3300 Series User Manual

Using the CX3300

Using Data Logger Mode

Using Data Logger Mode

In the Data Logger mode, the CX3300 supports the waveform recording and the
waveform playback. The waveform recording enables you to collect continuous
waveform data and save it as the waveform database. The waveform playback
enables you to replay and analyze the waveform database. The Data Logger mode
can be used to obtain waveform data for the duration of up to 100 hours by using
an internal/external storage device (HDD/SSD). To analyze such a huge amount of
waveform data, Waveform Analytics tool palette and Waveform Trend Analyzer are
available.
Data Logger mode is available for the CX3300 with the option STG. License is
required to use this mode. For the installation of the license, refer to the CX3300
online help.

Waveform Recording

You can capture a long-duration waveform and save it in a waveform database as
shown below.
1. Perform the waveform measurement in the Scope mode with several
2. Click the Data Logger tab on the main waveform window to switch the mode.
3. Change the setup on the Data Logger dialog box if necessary. Refer to the
4. Press the Single key or click the Record icon to start the waveform recording.
The waveform recording will be stopped after the sampling duration elapsed. You
can also use the Run/Stop key or the Stop icon to stop the waveform recording.
After that, the recorded waveform database will be saved and loaded
automatically. Then the waveform playback is ready.
70
measurement setups. Finally, decide the setup for the waveform recording and
stop the waveform measurement.
The Data Logger dialog box will open.
CX3300 online help for details of the setup parameters.
Keysight CX3300 User's Guide, Edition 5