Edge/Center Erase - Xerox DocuColor 5252 Operator's Manual

Scanner

Edge/Center Erase

Edge/Center Erase allows you to erase the Left/Right edge, Top/
Bottom edge, and Center from 0 to 50 mm in increments of 1 mm.
Left/Right and Top/Bottom can be set independently.
Edge Erase is proportional to Reduce/Enlarge. For example, if
Edge Erase is set for 30 mm and 50% reduction is programmed
then the amount of Edge Erase will be 15 mm on the output.
When using 2-Sided Output, the same amount of erasure applies
to sides 1 and 2.
Center Erase erases the shadow line from scanning the spine of a
bound original (for example a book or a magazine). It is also
useful for erasing the boundary line between two documents
placed side by side on the Document Glass.
Center Erase may be specified between 0-50 mm in increments of
2 mm. When you specify a value, each side of the center is erased
by half of the specified value. A Center Erase value of 30 mm
results in 15 mm being erased from either side of the center.
For some original image sizes, Edge/Center Erase does not occur
exactly in the center of the output image. Center Erase default is 0
mm., which can be changed in Tools Mode. Refer to the System
Administration Guide (see page 2-75) for more information on how
to change this setting.
Do c u Co lo r 52 5 2 O pe r a to r Ma n ua l
5-59