Edge/Center Erase - Xerox DocuColor 2060 Operator's Manual

S
C A N N E R
4–46

Edge/Center Erase

Edge/Center Erase allows you to erase the Left/Right edge, Top/Bottom edge,
and Center from 0 to 50 mm in increments of 1 mm. Left/Right and Top/Bottom
can be set independently.
Edge Erase is proportional to Reduce/Enlarge. For example, if Edge Erase is set
for 30 mm and 50% reduction is programmed then the amount of Edge Erase will
be 15 mm on the output.
When using 2-Sided Output, the same amount of erasure applies to sides 1
and 2.
Center Erase erases the shadow line from scanning the spine of a bound original
(for example a book or a magazine). It is also useful for erasing the boundary line
between two documents placed side by side on the Document Glass.
Center Erase may be specified between 0-50 mm in increments of 2 mm. When
you specify a value, each side of the center is erased by half of the specified
value. A Center Erase value of 30 mm results in 15 mm being erased from either
side of the center.
For some original image sizes, Edge/Center Erase does not occur exactly in the
center of the output image. Center Erase default is 0 mm, which can be changed
in Tools Mode. Refer to the System Administration Guide for more information on
how to change this setting.
D O C U C O L O R
2 0 60 /2 0 45
O P E R A T O R M A N U A L