Xerox DocuColor 5252 Operator's Manual page 278

P r ob l em s ol v i n g
Problem
The digital press does not power on
(continued).
Prints are not on desired paper size.
Misregistration of the scan to print
image from the Document Glass.
Paper is misfed or wrinkles
repeatedly.
7- 2
Suggested solutions
• Check the GFI circuit breaker switch.
• If the power in your location is working properly, you have tried
the suggested solutions, and the digital press power does not
power on, call for assistance.
• Ensure that the proper paper is loaded in the paper trays.
• Select the paper size, tray and weight through the digital press
options on your PC.
• Ensure that the correct weight is selected on the tray.
• Ensure that "Fit to Paper" or an equivalent selection is not
selected in your print driver.
• Go into Tools Mode and adjust registration. Refer to the Tools
Mode in the System Administration Guide (see page 2-45).
• If a message appears on the Touch Screen, follow the
instructions displayed and refer to the information in this
chapter.
• Ensure the proper paper (refer to the Paper chapter of this
manual and the Recommended Materials List) is loaded
correctly and not filled above the MAX line.
• Turn the paper stack around and/or over in the selected paper
tray.
• Remove a few sheets from the top and the bottom of the stack
in the paper tray.
• Fan all four edges of the paper in the selected paper tray.
• Replace the paper in the selected paper tray with paper from a
new package.
• Remove any partially fed paper from the trays.
• Ensure the paper you are using had been stored properly.
D oc u Co l or 5 25 2 O pe r a to r M a nu a l