Xerox DocuColor 5252 Operator's Manual page 274

A c c es s o r i es
Problem
Fault Code 112-110
Fault Code 052-310
Fault Code 052-321
Fault Code 052-320
Fault Code 052-312
Ready Indicator does
not illuminate
Poor Stacking:
Paper Jams:
6- 4 8
Cause
Paper jammed in the
HCSS and the Exit
Module during a purge of
sheets to the Top Tray.
Communication problem
Connection problem
Unexpected connection
Communication problem
No power
Mixed sizes of paper
High paper curl
Mechanical obstruction
Use Top Tray
High paper curl
Solution
• Clear the jammed paper from the HCSS.
• Clear the jammed paper from the Exit Module.
• Open and close the HCSS door.
• Resume job.
• Cancel or save the job.
• Power off the digital press. Wait 15 seconds and
power on.
• Cancel or save the job.
• Power off the digital press. Wait 15 seconds and
power on.
• Cancel or save the job.
• Power off the digital press. Wait 15 seconds and
power on.
• Cancel or save the job.
• Power off the digital press. Wait 15 seconds and
power on.
• Check the power cord connected to the power
source.
• Check that the main switch is on.
Run separate jobs and empty stacker.
• Adjust digital press decurler.
• Flip paper in digital press paper tray(s).
• Rotate paper in the digital press paper tray(s).
• Check for obstruction in the stacker stapler paper
path.
• Ensure that all transports and baffles are properly
seated.
Deselect offset or restart job to the Top Tray.
• Adjust digital press decurler.
• Flip paper in digital press paper tray(s).
• Rotate paper in the digital press paper tray(s).
• Switch to heavier paper.
D oc u Co l or 5 25 2 O pe r a to r M a nu a l