S c an n er
5- 9 8
3
If a finishing device is attached to your configuration, select where
to feed the output. It is recommended that the transparencies be
output to the Top Tray even though both selections are valid.
4
If Transparency Set + Dividers or Dividers Only is selected,
indicate the paper tray where the dividers are loaded.
5
Touch the Save button.
6
Continue selecting options for your job.
7
When you are finished selecting options, press the Start button.
Figure 5-65
D oc u Co l or 5 25 2 O pe r a to r M a nu a l