A
C C E S S O R I E S
Problem
Fault Code 052-321
Fault Code 052-320
Fault Code 052-312
Ready Indicator does not
illuminate
Poor Stacking:
Paper Jams:
5–52
Cause
Connection problem
Unexpected connection
Communication problem
No power
Mixed sizes of paper
High paper curl
Mechanical obstruction
Use Top Tray
High paper curl
NOTE: To undock the HCSS from the digital press, reach into the circular area
near the bottom of the HCSS for the Undocking Lever. Refer to the picture below.
Undocking Lever
inside here
Pull the lever toward you and hold it in position while moving the HCSS a small
distance (25.4mm, 1") away from the press. Release the lever and continue to
move the HCSS as far as required.
H
C
S
I G H
A P A C I T Y
Solution
•
Cancel or save the job.
•
Power off the digital press. Wait 15 seconds and power on.
•
Cancel or save the job.
•
Power off the digital press. Wait 15 seconds and power on.
•
Cancel or save the job.
•
Power off the digital press. Wait 15 seconds and power on.
•
Check the power cord connected to the power source.
•
Check that the main switch is on.
Run separate jobs and empty stacker.
•
Adjust digital press decurler.
•
Flip paper in digital press paper tray(s).
•
Rotate paper in the digital press paper tray(s).
•
Check for obstruction in the stacker stapler paper path.
•
Ensure that all transports and baffles are properly seated.
Deselect offset or restart job to the Top Tray.
•
Adjust digital press decurler.
•
Flip paper in digital press paper tray(s).
•
Rotate paper in the digital press paper tray(s).
•
Switch to heavier paper.
Figure 31. HCSS Undocking Lever
2 0 60 /2 0 45
D O C U C O L O R
S
( H C S S )
T A CK E R
T A P L E R
O P E R A T O R M A N U A L