Edge Erase For Drilled Paper - Xerox DocuColor 2060 Operator's Manual

S
C A N N E R
4–44

Edge Erase for Drilled Paper

Edge Erase can be used to erase the black holes created when copying an
original that is printed on drilled paper. This can be used for 1-Sided and 2-Sided
scan to print jobs from the Duplex Automatic Document Feeder (DADF).
Using the Edge Erase feature for this purpose may cause some image loss on the
opposite side of the document.
Use the following procedure to use Edge Erase to erase black holes on output:
1
Choose the appropriate paper tray in the Paper Supply column on the Basic
Features screen.
2
Select Original Input on the Added Features screen. Select Manual Input and
Custom Size.
3
Make sure that the Y dimension is set to equal the length of the original being
copied.
4
Change the X dimension to a size equal to the width of the original minus the
edge amount for the holes.
For example, for an 8.5"x11" original, input 8" for the X dimension.
5
Press the Save button.
6
If you are have a 2-Sided scan to print job, select 2 Sided Output on the Added
Features screen. Select 2-2 Sided. Select Head to Head in both the Images on
Original and Images on Copy columns.
7
Press the Save button. Select any other features needed for the job.
8
Place the originals into the DADF in the short edge feed direction with the holes
facing the user.
You will get an Image Orientation Mismatch fault when the originals are being
scanned. Select Yes to rotate the image.
9
Another screen will appear asking if you want to continue with the job, select
Resume Scan.
The scan to print job will then be output.
2 0 60 /2 0 45
D O C U C O L O R O P E R A T O R M A N U A L