Problem Solving - Xerox DocuColor 2060 Operator's Manual

A
C C E S S O R I E S

Problem Solving

Problem
Fault 052-311
Fault 212-252
Fault 212-253
Fault 212-251
Fault 212-254
Ready Indicator does not
illuminate
Poor Stacking
5–34
If, after following the recommended solutions, the problem persists, call for
assistance.
The Fault Codes described below appear on the HCS display panel.
Cause
Communication problem •
•
HCS Flipper wheel •
problem.
•
•
HCS Flipper wheel •
problem.
•
•
HCS Stacking Height •
problem
•
•
HCS Registration problem •
•
•
No power •
•
•
Mixed sizes of paper Run separate jobs and empty stacker.
High paper curl •
•
•
•
H C
I G H A P A C I T Y
Solution
Cancel or save the job.
Power off the digital press. Wait 15 seconds and power on.
Open Top Cover.
Clear the paper path.
If the fault code is still displayed, save or cancel the job, then
power off the digital press. Wait 15 seconds and power on.
Open Top Cover.
Clear the paper path.
If the fault code is still displayed, save or cancel the job, then
power off the digital press. Wait 15 seconds and power on.
Open Top Cover.
Clear the paper path.
If the fault code is still displayed, save or cancel the job, then
power off the digital press. Wait 15 seconds and power on.
Open Top Cover.
Clear the paper path.
If the fault code is still displayed, save or cancel the job, then
power off the digital press. Wait 15 seconds and power on.
Check the power cord connected to the power source.
Check that the GFI circuit breaker is not tripped (rear cover).
Check that the main switch is on.
Adjust digital press decurler.
Flip paper in digital press paper tray(s).
Rotate paper in the digital press paper tray(s).
Switch to heavier paper.
2 0 60 /2 0 45
D O C U C O L O R
S ( H C S )
T A CK E R
O P E R A T O R M A N U A L