Enhanced High Capacity Stacker Operator Manual for DocuColor 2060/2045...
, The stylized X, and all Xerox product names and product numbers mentioned in this publication are trademarks of XEROX CORPORATION. Other company brands and product names may be trademarks or registered trademarks of the respective companies and are also acknowledged.
F O R D O C U C O L O R Safety Notices This Xerox digital press and the recommended supplies have been designed and tested to meet strict safety requirements. Attention to the following notes will ensure the continued safe operation of your digital press.
If any of the following conditions occur, immediately switch off the power to the machine and disconnect the power cord from the electrical outlet. Call an authorized Xerox service representative to correct the problem. – The machine emits unusual noises or odors.
Do not perform any maintenance procedures unless you have been trained to do them by a Xerox representative, or unless a procedure is specifically described in one of the manuals included with your press.
A F E T Y O T I C E S Operational Safety Your Xerox equipment and supplies were designed and tested to meet strict safety requirements. These include safety agency examination, approval, and compliance with established environmental standards. Your attention to the following safety guidelines will help ensure the continued safe operation of your digital press: •...
Xerox installation procedures, ensures that concentration levels meet safe limits. If you need additional information about ozone, request the Xerox publication, OZONE, 600P83222, by calling 1-800-828-6571 in the USA. For a French language version, call 1-800-828-6571 in the USA, then press 2.
A F E T Y O T I C E S This page is intentionally blank. E H C S 2 0 60 /2 0 45 O vi ii F O R D O C U C O L O R P E R A T O R A N U A L...
Changes or modifications to this equipment not specifically approved by the Xerox Corporation may void the user’s authority to operate this equipment. Shielded cables must be used with this equipment to maintain compliance with FCC regulations.
Safety Extra Low Voltage Approval Certifications in Europe This Xerox digital press is in compliance with various governmental agencies and national safety regulations. All system ports meet the Safety Extra Low Voltage (SELV) circuits for connection to customer-owned devices and networks.
It’s Illegal in the USA E HC S 2 06 0/ 2 04 5 O F O R D O C U C O L O R Congress, by statute, has forbidden the reproduction of the following subjects under certain circumstances. Penalties of fine or imprisonment may be imposed on those guilty of making such reproductions.
O T I C E S xi i 2. Adjusted Compensation Certificates for Veterans of the World Wars. 3. Obligations or Securities of any Foreign Government, Bank, or Corporation. 4. Copyrighted material, unless permission of the copyright owner has been obtained or the reproduction falls within the “fair use”...
It’s Illegal in Canada E HC S 2 06 0/ 2 04 5 O F O R D O C U C O L O R Parliament, by statute, has forbidden the reproduction of the following subjects under certain circumstances. Penalties of fines or imprisonment may be imposed on those guilty of making such copies.
Xerox ENERGY STAR equipment is preset at the factory to enter a “low power” state and/or shut off completely after a specified period of use. These energy- saving features can reduce product energy consumption in half when compared to conventional equipment.
For more information about Xerox environmental programs, visit www.xerox.com (refer to the “About Xerox” section). If your product is not part of the Xerox program and you are managing its disposal, please note that the product may contain lead, mercury and other materials whose disposal may be regulated due to environmental considerations.
O T I C E S This page is intentionally blank. E H C S 2 0 60 /2 0 45 O xv i F O R D O C U C O L O R P E R A T O R A N U A L...
Symbols E HC S 2 06 0/ 2 04 5 O F O R D O C U C O L O R Conventions Standardized conventions have been used in this manual to assist you in visually locating and identifying information quickly. CAUTION: This symbol alerts you to an action that may cause damage to hardware, software, or result in the loss of data.
O N V E N T I O N S xv i ii KEY POINT: This symbol identifies information that is being emphasized and is important for you to remember. The 1 2 3... symbol indicates the beginning of a task or work process you should use to complete a procedure and is followed by the first step of a numbered procedure, task, or work process.
(or 370mm high). The Top Tray has a capacity of 250 sheets of 24 lb 90 gm centerline paper. The EHCS is supplied with two Stacker Carts. If needed, you can purchase an additional Stacker Cart. Contact your Xerox representative for further details.
N H A N C E D H I G H C A P A C I T Y S T A CK E R Identifying the Parts Control Panel Front Door access to Stacker Top Tray Figure 1. Enhanced High Capacity Stacker E H C S 2 0 60 /2 0 45 O F O R D O C U C O L O R...
Control Panel Name Ready light The Ready light blinks during initialization and is constant when the EHCS is in use or in standby mode. Sample set Press to have the EHCS deliver the next collated set to the top tray. button Unload Press once to lower the Stacker Tray and unlock the front door.
• Uncoated: Xerox Digital Color Xpressions +, 90 g/m Digital Color Colotech+ 90 g/m • Coated: Xerox Digital Color Gloss Coated Text (120 g/m Xerox Digital Color Colotech + Gloss Coated 120 g/m P E R A T O R...
Unloading the Stacker Tray E HC S 2 06 0/ 2 04 5 O F O R D O C U C O L O R N H A N C E D H I G H C A P A C I T Y S T A CK E R Use the following procedure to unload the Stacker Tray when it is full, or you want to retrieve a job that has been completed.
N H A N C E D H I G H C A P A C I T Y S T A CK E R Selecting Features Obtaining a Sample Set If sending a job through the network, refer to the documentation that came with your color server for information on how to select stacker options on the print driver screens.
E HC S 2 06 0/ 2 04 5 O F O R D O C U C O L O R N H A N C E D H I G H C A P A C I T Y S T A CK E R On the next screen, make the desired selections under Output Delivery and Output Assembly, then touch the Stacker button.
• Ensure that the digital press power is on and the Ground Fault Indicator is in the On position. • If the power has not been restored by the above procedure, call Xerox Customer Support. Also call your Xerox service representative if the loss of power to the EHCS seems to be frequent or excessive.
N H A N C E D H I G H C A P A C I T Y S T A CK E R E H C S 2 0 60 /2 0 45 O F O R D O C U C O L O R P E R A T O R A N U A L...
701P40232 June, 2003 Xerox Corporation Global Knowledge and Language Services 780 Salt Road Webster, New York 14580...