Xerox DocuColor 2060 Operator's Manual page 228

A
C C E S S O R I E S
Problem
Repeated Tray 4 misfeeds.
Tray 4 does not feed.
Misfeeds occur with
lightweight paper.
Prints are skewed.
Touch Screen displays
"Add Paper" message and
there is paper in the tray
selected
5–16
• Turn the paper stack around or over in the Elevator Tray.
• Replace the paper in the tray with paper from a new package.
• Keep paper in the original wrapper and store it flat in a dry environment when not in use.
• Fan the paper at all four corners. Change it if it has uneven edges.
• Lightweight or heavyweight paper may not feed with as much reliability as papers that are
2
64 to 220 g/m .
• Remove a few sheets from the top and the bottom of the ream in the Elevator Tray.
• Ensure that the paper is loaded evenly to the edge of the tray and not overloaded.
• Check to ensure that the side guides are lightly against the paper and not too tight.
• If the environment is high humidity (50 to 85%) and coated paper is being used, the Tray 4
Heater Kit may have to be installed.
• The digital press should be set to feed from Tray 4.
Use a heavier weight paper.
Ensure that the Rear and Side Guide Adjustment Levers are in the correct position.
If the Coated Paper button at the front of Tray 4 is selected and Uncoated Paper is not
programmed on the Touch Screen or in the RIP print driver screen, an incorrect message, "Add
Paper" is displayed. Change the settings so they are consistent.
For additional help, call your Xerox representative.
Follow the instructions below before calling for service.
1
Be prepared to provide a complete description of the problem to the service
operator. Defining the problem accurately may help you and the operator solve
the problem over the phone and minimize downtime. If the problem cannot be
solved by telephone, a service representative will be dispatched to your site
promptly.
2
Record the displayed Fault Codes.
Suggested Solutions
2 0 60 /2 0 45
D O C U C O L O R
T 4
R A Y
O P E R A T O R M A N U A L