Xerox 6030 User Manual page 94

Centronics (optional, 6030/6050 Only)
The Centronics communication parameters are presented below.
Ack Mode
DMA Timeout
EOP Timeout
Job Separation
66
Menu Item
The Ack mode is selected from [MODE0], [MODE1],
[MODE2], [MODE3], and [MODE7].
The default setting is [MODE0].
The timeout value for data input is entered within a range
of 1 to 255 seconds. The default setting is [5 sec].
Determines if the EOP Timeout will be enabled [TIMEOUT]
or disabled [NO_TIMEOUT]. If set to [TIMEOUT], a
Timeout Value must be entered. The timeout value is
entered within a range of 0 to 99 seconds.
The default setting is [10 sec].
Sets the job separation. The default setting is [NO].
[YES]
[NO]
• If a value higher than [255] is entered for the DMA Timeout value, [255] will
be set as the value.
• Changes to the [Ack Mode] and [DMA Timeout] values will have no effect on
operations.
Description
Starts conversion processing once the
command that recognizes the end of the
data is received, even if this occurs midway
through the file.
Performs the spooling process on the hard
disk until a timeout is issued.
Chapter 3 Printer Setup