Xerox 6030 User Manual page 98

PORT SETTING
TCP/IP
TCP/IP
Default Parser
Default Parser
HPGL
IP Address
100. 000. 000. 000
IP Address
120. 000. 000. 000
IP Address
123. 123. 123. 001
70
1
Display [TCP/IP] on the selection screen,
and then press the <
2
Select the item that is to be set up with the
use of the < > and < > keys, and then
press the <
[Ethernet Setting], [Default Parser], [IP
Address], [Mask Value], [E-Net Address],
[Dynamic Routing], and [Static Routing] will
be displayed in that order.
3
Select the parameters with the use of the
*
< > and < > keys, and then press the
<Set> key.
An asterisk [*] will be displayed on the right
side of the parameters once they have been
set.
1. Move the cursor to the left and right with
the use of the <
2. Select the required value with the use of
the < > and < > keys. The value will
increase or decrease sequentially
between 0 and 9.
*
3. Press the <Set> key once all values have
been entered.
> key.
• Additions can be made to the
routing table when [Static Routing]
is enabled.
• The [E-Net Address] can only be
displayed, not changed.
Entering addresses
> and <
• To proceed to the next menu, move
the cursor to the right-hand side
and press the <
• To return to the previous menu,
move the cursor to the left-hand
side and press the <
Chapter 3 Printer Setup
> key.
> keys.
> key.
> key.