Communication Parameter Setup (Print Services On Web, 6030/6050) - Xerox 6030 User Manual

3.4
Communication Parameter Setup (Print
Services on Web, 6030/6050)
The communication parameters for TCP/IP, Serial, Centronics (optional), VPI
(optional), and SNMP can be set up from Print Services on Web. These
procedures are explained below.
Procedure
1

3.4 Communication Parameter Setup (Print Services on Web, 6030/6050)

• The machine must be rebooted for the changes to take effect.
• These procedures are performed in the Administrator Mode.
Start Print Services on Web, enter the Administrator mode, and select
the [Properties] tab.
Refer to "2.3 Print Services on Web (6030/6050)" for details about
starting Print Services on Web and logging on as Administrator.
The displayed [Print settings] were set up earlier using the selections on
the [Print Setup] and the [Properties] tabs. The hardware configuration
information is stored in the machine's controller.
75