Xerox 6030 User Manual page 321

Command name
Set Blue Parameter
Assign Color Index
Number
Push/Pop Palette
Start Raster
Graphics
End Raster Graphics
Transfer Raster Data
by Plane
Transfer Raster Data
by Row/Block
Set Compression
Method
Source Raster Width
Source Raster
Height
Move CAP
Horizontal
(Decipoint)
Move CAP
Horizontal
Move CAP Vertical
Y Offset
Appendix 3 HP-RTL Command List (6030/6050)
Command Command Meaning and function
ESC * v # c|C Defines the blue color configuration of
the color palette.
ESC * v # i|I Assigns a defined RGB parameter to
an index number.
ESC * p # P Saves and restores palette
information.
ESC * r # a|A Sets the controller to the raster mode
and sets the start position and left
margin of a graphic image.
ESC * r C Indicates the end of raster graphic
image transfer.
ESC * b # V[data] Transfer's the data of a specified byte.
However, the CAP does not move to
the next raster position.
The plane pointer is updated but the
row pointer is not.
ESC * b # Transfer's the data of a specified byte
W[data]
as a line or as a block by the current
compression method.
ESC * b # m|M Determines the compression method.
ESC * r # s|S Indicates the image width of
succeeding raster data.
ESC * r # t|T Indicates the source raster image
height of succeeding raster data.
Moves the CAP horizontally by a
ESC & a # h|H
specified decipoint (1/720 inch).
ESC * p # x|X Moves the CAP horizontally by a
specified value in Versatec resolution
inch units.
Moves the CAP vertically by a
ESC * p # y|Y
specified value in Versatec resolution
inch units.
ESC * b # y|Y Moves the CAP vertically by specified
pixel rows.
Limit
Only
concatenation
command valid
Index Number
Ignored
Data skipped
11