Network Topology and Connection
Single Computer and Single Power Supply Unit
M370078-06
The following section describes the network topology for the single
computer and single XG power supply unit. The other possible network
topologies will be discussed later in the "Advanced Section" on page 2–
26. The additional topologies build on the configuration ideas present in
this section by referencing the various setup instructions.
Figure 2-6 shows the connection between the ENET unit and Local
Computer through a crossover cable; however, a HUB could also be used
with straight through Ethernet cables as well. Connect your computer to
the ENET as shown in Figure 2-6, or if this topology does not match your
configuration, refer to the "Advanced Section" on page 2–26 to identify
the topology you wish to implement and follow the instructions described
in that section.
Local Computer
Figure 2-6 Single Computer, Single Power Supply
Basic Section
ENET
Power Supply
2-5