Basic Setup Procedure; Ethernet - Xantrex ENET-XFR Operating Manual

Installation and Configuration

Basic Setup Procedure -

Table 2-3

Ethernet

S t e p # D e s c r i p t i o n
1 Mode
Configuration
2 Ethernet
Connection
3 User Signal
Connector
4 Power ON
5 Locate your
power supply on
your network
6 Configure the
Ethernet Bridge
7 Test
2–10
This procedure can be used as a quick reference for those familiar with
the configuration requirements for the
installed in the DC power supply. For those who want more information,
each step refers to more detailed procedures located in subsequent
sections. Execute each step of the procedure in the sequence given.
Setup Procedure
A c t i o n
Configure for Ethernet
communications.
Connect the CAT 5 network cable to
the Ethernet connector on the
supply.
Configure and use the user line
connector signals, if required.
Power on the unit and wait 45
seconds for the Ethernet Bridge to
complete its start-up routine. Before
proceeding, check to ensure that the
green NETwork LED on the back
panel is ON.
Load the Setup Software that ships
with this interface card.
Access the device's web server/
configuration page.
Begin Communicating with your
instrument.
Ethernet
Ethernet/RS-232 Interface
R e f e r e n c e
See
232" on page
See
page
See
page
See
if the NETwork LED does not stay
illuminated after startup has
completed.
See
Your Network" on page
See
on page
If you do not have a TCP/IP based
software application suitable for this
application, and are familiar with RS-
232 type communications, see
"Installing and Using RealPort®" on
page
"Configuring for Ethernet or RS-
2–12.
"Ethernet Connection" on
2–13.
"User Lines Connector" on
2–26.
"Troubleshooting" on page 3–20
"Locating the Power Supply on
2–14.
"Configuring Ethernet Bridge"
2–15.
2–16.
TM-XR9B-01XN
as