Table 3-5 Calibration Commands; Table 3-6 Status Commands - Xantrex ENET-XFR Operating Manual

Operation
3–8

Table 3-5 Calibration Commands

C o m m a n d D e s c r i p t i o n
CMODE Places the supply into calibration mode.
IDATA Calculates the slope and intercept for current programming.
IHI Sets the current output to the high calibration point.
ILO Sets the current output to the low calibration point.
IRDAT Calculates the slope and intercept for current readback.
IRHI Sets the current output to the high readback point.
IRLO Sets the current output to the low readback point.
OVCAL Calibrates the over voltage protection (OVP).
VDATA Calculates the slope and intercept for voltage programming.
VHI Sets the voltage output to the high calibration point.
VLO Sets the voltage output to the low calibration point.
VRDAT Calculates the slope and intercept for voltage readback.
VRHI Sets the voltage output to the high readback point.
VRLO Sets the voltage output to the low readback point.

Table 3-6 Status Commands

C o m m a n d D e s c r i p t i o n
ASTS? Asks for the supply's accumulated status register.
FAULT? Asks for the supply's fault register for the status preset operating
conditions.
MASK Prevents the supply's previously unmasked operating conditions
from setting bits in the fault register.
STS? Asks for the supply's present status register.
UNMASK Enables you to select those supply's operating conditions that you
are most interested in monitoring for fault occurrence.
UNMASK? Asks for the supply's fault conditions which are currently enabled
(unmasked).
TM-XR9B-01XN