Table 2-4; Basic Setup Procedure - Rs - Xantrex ENET-XFR Operating Manual

Basic Setup Procedure -

Table 2-4

RS-232
S t e p D e s c r i p t i o n
1 Mode
Configuration
2 Baud Rate
Selection
3 Flow Control
Selection
4 Remote/Local
Operation
5 RS-232
Connection
6 User Signal
Connector
7 Power ON
8 Power Supply
Settings
9 Test
TM-XR9B-01XN
This procedure can be used as a quick reference for those familiar with
the configuration requirements for the
installed in the DC power supply. For those who want more information,
each step refers to more detailed procedures located in subsequent
sections. Execute each step of the procedure in the sequence given.
Setup Procedure
A c t i o n
Configure for RS-232
communications.
Select transmission speed.
(Default 9600)
Select flow control ON or OFF.
(Default is OFF) If flow control is
set ON, choose software-based
XON/XOFF or hardware-based
RTS/CTS communication control.
The factory default is PON REM.
Connect the RS-232 cable assembly
to the RS232 connector on the
supply.
Configure and use the user line
connector signals, if required.
Power on the unit.
Configure the controller's operating
parameters to match the power
supply settings.
Test the link by communicating with
the power supply.
RS-232
Ethernet/RS-232 Interface
R e f e r e n c e
See
232" on page
See
page
See
page
See
page
See
page 2–23
See
page
See
Settings" on page 2–24
Signals" on page 2–26
information about Local/Remote
OVP, TTL Shutdown, and auxiliary
connector user signals.
See
page
Example: VSET2;ISET1
This command string sets power
supply voltage to 2V and its current
limit to 1A.
See "Operation".

Basic Setup Procedure - RS-232

"Configuring for Ethernet or RS-
2–12.
"Baud Rate Selection" on
2–18.
"Flow Control Selection" on
2–19.
"Remote/Local Operation" on
2–20.
"Power Supply Settings" on
"User Lines Connector" on
2–26.
"Additional User Options and
and
for
"Power Supply Settings" on
2–23.
as
"User
2–11