Installation and Configuration
Front Panel
Remote Programming LEDs. See table.
Figure 2-1 Power Supply Front Panel with
(1200 Watt Power Supply Shown)
2–4
Figure 2-1
shows the front panel of an XFR 1200 Watt supply with
Ethernet/RS-232 Interface
Remote Programming LEDs in
Remote LED (REM)
Table 2-1 Remote Programming LEDs
L E D
D e s c r i p t i o n
ADR
Address: Indicates that the master controller is addressing the unit.
SRQ
Service Request: (GPIB only)
ERR
Error: Indicates when a programming error has occurred. You can
clear the ERR LED with an error query command.
FLT
Fault: Indicates that a fault has occurred. The fault bit must be
unmasked. Refer to the status register in
Momentarily lights if PON SRQ is set to on.
POL
Polarity: Indicates that the polarity user line has been activated.
See
"User Lines Connector" on page
installed. There is a further description of the
Table
2-1.
Ethernet/RS-232 Interface
Local Switch (LOCAL)
Installed
Table 3-8 on page
2–26.
TM-XR9B-01XN
3–18.