Remote Mode Operation; Table 2-10 Remote Mode Power On Conditions - Xantrex ENET-XFR Operating Manual

Remote Mode Operation

TM-XR9B-01XN

Table 2-10 Remote Mode Power On Conditions

C o n d i t i o n
Voltage
Current
Soft Voltage Limit
Soft Current Limit
OVP Trip Voltage
Delay
Remote Enable
Foldback Protection
Output
Hold
Unmask
AUXA
AUXB
While in remote mode, use the interface commands to control the output
of the power supply from a computer. See
of device-dependent commands available with this interface.
From remote mode, change to local mode operation by pressing the front
panel LOCAL button or by sending either the GTL command or the
REN OFF command. You can disable the LOCAL button by using the
LLO command. For an example of how to use Local Lockout, see
Lockout (LLO) Command" on page
To return to remote mode, ensure that the REN command is set to ON and
then send any valid device-dependent command. Since the remote mode
output settings may be different from the local mode settings, the output is
programmed to protect the load by turning off when you toggle from local
to remote mode during a session. Check your remote settings and then
send OUT ON to restore the output.
D e f a u l t S e t t i n g s
0 V
0 A
VMAX (see models)
IMAX (see models)
Model VMAX + 10%
0.5 s
ON
OFF
ON
OFF
NONE
OFF
OFF
2–23.
Remote/Local Operation
7 . 5 - 1 4 0 M o d e l E x a m p l e
VSET 0
ISET 0
VMAX 7.5
IMAX 140
OVSET 8.25
DLY 0.5S
REN ON
FOLD OFF
OUT ON
HOLD OFF
UNMASK NONE
AUXA OFF
AUXB OFF
"Operation" for a complete list
"Local
2–21