Lucent Technologies DEFINITY AUDIX Installation And Upgrade page 139

Software Upgrade
20. Log in to the DEFINITY AUDIX system as craft. Wait for Active to appear
on the status line before continuing.
21. [less than 1 min]
Run
TEST TAPE CLEAN
22. [1 min]
Check the Alarm Status at the top of the screen. If there are alarms, enter
DISPLAY ALARMS at the command line and take the appropriate
action to remove the alarms. Consult DEFINITY AUDIX System —
Maintenance, 585-300-110, for information on removing alarms.
23. [10 min]
Call the DEFINITY AUDIX system and log in as a subscriber. Verify that the
DEFINITY AUDIX system is in service and working properly; create, send,
and retrieve a message.
24. [1 min]
Remove the language set tape. Insert a customer backup tape to be used
for the automated saves.
25. [10 min]
Run
ADD TAPE
Name field. (The new volume name must be different from the name
already in this field, if any.)
26. Press
about releases not matching. Check the status of the
using the
the
STATUS TAPE
LEDs and State Exceptions.
27. For any upgrade (except when the release is already at R3.2) to work
correctly, the Transfer Dialplan information must be administered before
the first nightly backup. If this is not done, after the backup is run, the
DEFINITY AUDIX will not allow call transfer to work. Refer to the DEFINITY
AUDIX System R3.2 Screens Reference, 585-300-211, for information on
administering this screen.
28. Run
DISPLAY TAPE
Release 3.2.
29. If the administration alarm, A, appears on the status line, clear the alarm
by running
The administration alarm should now be gone from the status line. If the
command prompt fails to appear, press
30. [5 min]
Run
SAVE NIGHTLY
When the administration alarm, A, appears on the status line, run
ADMINISTRATION-LOG
completed,
to reset the tape cleaning interval counter.
to equip the tape. Enter a new volume name in the Volume
to invoke the add-tape operation. Ignore any warnings
RETURN
screen. When the
STATUS TAPE
screen will show
to verify that the backup tape Software Release is now
DISPLAY ADMINISTRATION-LOG
.
. If the
SAVE NIGHTLY
save manual_nightly passed
ADD TAPE
operation is complete,
ADD TAPE
In service, idle . Check
and pressing
ENTER
.
CANCEL
operation was successfully
will be displayed.
Issue 2 December 1996
operation
the status of the
(F3).
DISPLAY
7-21