Lucent Technologies DEFINITY AUDIX Installation And Upgrade page 124

Upgrades to R3.2
Task
6. Add control link cable, if
necessary.
7. Continue with step 7 of
software upgrade and
complete software
upgrade.
8. Change switch integration,
if necessary.
The following may be
required changes:
Increase voice ports,
keeping digital port
emulation the same
NOTE:
Voice ports for the B voice
files will be rebuilt during an
upgrade.
Change voice ports from
CL analog to CL digital
NOTE:
Only G3V4 and updated
G3V2 and G3V3 support
enhanced Call transfer if
using digital port emulation
and Control Link integration.
The transfer is invoked via a
message from the AUDIX
system to the switch on the
control link.
7-6
Issue 2 December 1996
Comments
Necessary if old system is
DP integration and new
system is CL integration.
Necessary if G3 switch and
customer wants to increase
ports, starting from 8 or
less ports and ending with
more than 8 ports.
Incorporates the TN2181
digital port emulation.
Necessary, if customer
has analog ports and wants
to add digital networking.
May incorporate the
TN2181 digital port
emulation. However, for
System 75, G1, or G3V1
switch where the customer
starts with more than 8
analog ports, this requires
dropping down to 8 or
fewer digital ports).
Where Task is Described
Chapter 2, Task 8: Install
the Control-Link Cable.
This chapter in section,
Software Upgrade.
Appendix A in Switch
Administration for the
DEFINITY AUDIX System
(585-300-509)
Appendix A in Switch
Administration for the
DEFINITY AUDIX System
(585-300-509)