Lucent Technologies DEFINITY AUDIX Installation And Upgrade page 108

Acceptance Checks
c. After the system greeting and the tone, leave a test message (for
d. Hang up.
2. Retrieve the Call Answer message.
a. If you are in contact with someone at the remote site, ask them to
b. Call the remote DEFINITY AUDIX extension. (If the remote switch is
c. When the DEFINITY AUDIX system answers and prompts you for
d. When prompted for your password, press
e. If the Name Record by Subscriber feature is on, the DEFINITY
f. Press
g. After listening to the message, press
3. Create a test Voice Mail message.
a. Call the local (host) DEFINITY AUDIX extension. Press
b. Press
c. When you have finished speaking the message, press
d. When prompted for a destination extension, enter the extension of
e. Press
f. Hang up.
4-12
Issue 2 December 1996
example, "This is a test Call Answer message.")
check the MWI — either a lamp on the phone or a stutter dial tone
— on the remote subscriber's phone. (The MWI signal may take up
to 1 minute to appear.) If it is on, proceed to the next step.
Otherwise, refer to the troubleshooting procedures in DEFINITY
AUDIX System — Maintenance , 585-300-110.
a System 85 or G2, this will be the same number as for the local
DEFINITY AUDIX System; for all other remote switch types, the
DEFINITY AUDIX extension for the remote switch will be different
from the extension for the local DEFINITY AUDIX system.)
your extension, enter the remote subscriber's extension and
press .
#
AUDIX system will prompt you to record a name. Record a test
name such as "test name."
then press
2 0
the first test extension.
prompted for your extension and when prompted for your
password.
to create a voice mail message. After the tone, speak a
1
test message (for example "This is a test Voice Mail message.").
approve the message.
the remote test subscriber and press
again to deliver now.
#
again.
#
to listen to the message you recorded from
to delete the message.
D
*
to end the addressing.
#
when
#
to
#