After The Upgrade; Installing, Administering, And Testing Intuity Message Manager - Lucent Technologies DEFINITY AUDIX Installation And Upgrade

Upgrades to R3.2
31. [5 min]
Run
SAVE WEEKLY
line, run
successfully completed,
32. Enable alarms by entering
33. If you do not have to install I
off the system. If I
continue with the After the Upgrade section of this document.
This completes the procedure for the R3.2 software upgrade.

After the Upgrade

If I Message Manager is part of the R3.2 upgrade, the language sets must
NTUITY
be added. Continue through the following sections.
Installing, Administering, and Testing I
Message Manager
Perform the following steps to install, administer, and test I
Manager. The LAN administrator should be present.
NOTE:
A 10BaseT twisted pair LAN cable with a male RJ-45 connector must be
present at the wall field before I
This is the customer's responsibility. Lucent Technologies will install the
I
NTUITY
this twisted pair is installed.
The connector can be no farther than 25 feet from the back of the switch where
DEFINITY AUDIX resides. Confirm with the LAN administrator prior to the
software upgrade that a connection is available.
1. Remove the top of the104A connecting block.
Inside, eight wires must be hard-connected across the two mounting
blocks, as shown in Figure 7-3, 104A Mounting Block . Four protector caps
snap over the top of the mounting blocks
7-22
Issue 2 December 1996
. When the administration alarm, A, appears on the status
DISPLAY ADMINISTRATION-LOG
save manual_weekly passed
ENABLE ALARM-ORIGINATION
NTUITY
Message Manager is going to be installed,
NTUITY
NTUITY
Message Manager to the demarcation point, but cannot test until
. If the
SAVE WEEKLY
will be displayed.
.
Message Manager, enter logoff to log
NTUITY
Message Manager can be in tested.
NTUITY
operation was
Message