Tyre Pressures; Wheel Nut Tightening; Hydraulic Oil Level; Washer Fluid Level (Option) - Manitou MC 25-2 D K ST3A S1 Operator's Manual

CHECK

CHECK
Check that the air hose is correctly connected to the tyre valve before inflating and keep all persons at a distance during inflation.
- Check the wheel nut tightening. Non-compliance with this instruction can lead to deterioration and breakage of the
wheel bolts and distortion of the wheels.
- Check and, if necessary, adjust the tyre pressures (
NOTE: There is an OPTIONAL wheel tool kit.
CHECK
Place the lift truck on level ground with the engine stopped, the mast tilted backward
and lowered as far as possible.
Use a clean funnel and clean the underside of the oil drum before filling.
- Refer to the dipstick 1.
- The oil level is correct when it is at the level of the red point.
- Visually check that there is no leakage in the tank and pipes.
- If necessary, add oil (
- Open the engine cover (
- Remove cap 2.
- Add oil through filler port 3.
- Visually check that there is no leakage in the tank and pipes.
NOTE: Always maintain the oil level at a maximum as cooling depends on the oil
flowing through the tank.
CHECK
- Open the engine cover (
- Visually check the level.
- If necessary, add windscreen washer liquid (
the filling hole 1.
IMPORTANT
Inflate to the recommended tyre pressures.
IMPORTANT
LUBRICANTS AND FUEL).
COMMAND AND CONTROL INSTRUMENTS).
COMMAND AND CONTROL INSTRUMENTS).
LUBRICANTS AND FUEL) through

Tyre pressures

Wheel nut tightening

TYRES).

Hydraulic oil level

Washer fluid level (option)

3 - 15
www.duma-rent.com
1
2
3
1