Bringing The Lift Truck Back Into Service - Manitou MC 25-2 D K ST3A S1 Operator's Manual

BRINGING THE LIFT TRUCK BACK INTO SERVICE

- Remove the waterproof adhesive tape from all the holes.
- Refit and reconnect the battery.
- Remove the protection from the cylinder rods.
- Perform the daily maintenance operations (
- Put the handbrake on and remove the axle stands.
- Drain and clean the fuel tank (
- Fill the fuel tank with clean diesel filtered through the filler port.
- Replace the fuel filter (
- Replace the fuel pre-filter (
- Drain and rinse the DEF tank
- Top up, slowly fill the tank with new "DEF" (Diesel Exhaust Fluid) up to the bottom of the filler neck
of lift truck)
- Refit the drive belts and adjust the tension (
- Turn the engine over with the starter, to allow the oil pressure to rise.
- Reconnect the engine cut-off solenoid.
- Lubricate the lift truck completely (
- Start up the lift truck, following the safety instructions and regulations (
LADEN).
- Run all the jib's hydraulic movements, concentrating on the ends of travel for each cylinder.
3 - MAINTENANCE).
3 - MAINTENANCE).
3 - MAINTENANCE).
3 - MAINTENANCE) (depending on the model of lift truck)
(depending on the model of lift truck)
3 - MAINTENANCE).
3 - MAINTENANCE).
IMPORTANT
Ensure the area is sufficiently ventilated before starting the lift truck.
OPERATING INSTRUCTIONS UNLADEN AND
1 - 19
www.duma-rent.com
(depending on the model