Fuel Pre-Filter; Radiator Core; Check - Adjust Tension And Alignment Of The Mast Lifting Chains; Clean - Manitou MC 25-2 D K ST3A S1 Operator's Manual

Hide thumbs Also See for MC 25-2 D K ST3A S1:
Table of Contents

Advertisement

CHECK - ADJUST
Place the lift truck on level ground with the mast vertical and the forks raised by
approximately 200 mm.
These checks are important to ensure correct mast operation.
In case of technical faults, consult your dealer.
- Check the alignment of the mast lifting chains between the carriage chain fasteners
and the chain rollers.
- Manually verify the chain tension and, if necessary, adjust it while ensuring that
the carriage is perpendicular to the mast.
- Loosen nut 1.
- Loosen the chain tensioner lock nut 2.
- Adjust the tension by tightening or loosening the nut 3 while checking the alignment of the lifting chains.
- Then tighten lock nut 2 and nut 3.
- Retighten the nut 1.

CLEAN

- Open the engine cover (
- Switch off the lift truck's ignition.
- Open the engine cover (
- Carefully clean the outside of the filter and its holder, to prevent dust from getting
into the system.
- Close the filter tap 1 in the OFF position.
- Unscrew the retaining ring 2, remove the housing 3 and clean the inside using a
brush immersed in clean diesel oil.
- Remove the filter cartridge 4 and immerse it in diesel oil to rinse it.
- Clean the inside of the filter head using a brush immersed in clean diesel oil.
- Refit the unit.
- Tighten the ring by hand pressure only and lock with a quarter turn
- Open the filter tap 1 in the ON position.
- Bleed the fuel supply circuit (
CLEAN
In a polluting atmosphere, clean the radiator cores every day.
Do not use a water jet or high pressure steam as this could damage the fins.
- Open the engine cover (
- Using a soft cloth, clean the core in order to remove as much dirt as possible.
- Clean the radiator using a compressed air jet aimed from the engine towards the
radiator, in the opposite direction to the cooling air flow.
Tension and alignment of the mast lifting chains
IMPORTANT
COMMAND AND CONTROL INSTRUMENTS).
COMMAND AND CONTROL INSTRUMENTS).
OCCASIONAL SERVICE).
IMPORTANT
COMMAND AND CONTROL INSTRUMENTS).
3 - 16
www.duma-rent.com
1
2

Fuel pre-filter

Radiator core

3
1
4
3
2

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mc 25-4 d k st3a s1Mc 30-2 d k st3a s1Mc 30-4 d k st3a s1Msi 25 d k st3a s5Msi 30 d k st3a s5Msi 35 d k st3a s5

Table of Contents