Check; Coolant Level; Fuel Level; Clean - Manitou MC 25-2 D K ST3A S1 Operator's Manual

CHECK

Place the lift truck on level ground with the engine stopped, and allow the engine to cool.
To avoid any risk of spraying or scalding, wait until the engine has cooled down before removing the cooling system
In the event of an emergency, it is possible to use water as the coolant, but then replace with coolant as quickly as
- Open the engine cover (
- The liquid must be at the MAXIMUM level on the expansion tank 1.
- If necessary, add coolant (
- Add coolant via filler port 2.
- Visually check that there is no leakage in the radiator and pipes.
CHECK
As far as possible, keep the fuel tank well filled in order to reduce condensation.
- Remove cap 1.
- Fill the fuel tank with clean fuel (
strainer or a clean, lint free cloth, through filler port 2.
- Put the cap 1 back.
- Visually check that there is no leakage in the tank and pipes.
Never smoke or approach with a flame during filling operations or when the tank is open.
The fuel tank is degassed via the filling hole. When changing it, always use an original plug with a degassing hole.

CLEAN

The frequency of cleaning is given as an example. However, as soon as impurities reach
the MAX level on the tank, the pre-filter must be emptied and cleaned.
When cleaning, take care not to let impurities into the dry air filter.
- Loosen nut 1 remove cover 2 and empty the tank.
- Clean the pre-filter unit with a clean dry cloth.
- Refit the unit.
CLEAN
The frequency of cleaning is given as an example.
- Clean the inside of the overhead guard or the cab using a small brush, vacuum cleaner and a cloth.
NOTE: As a cap option, protect the cab ventilation filter located under the floor mat.
IMPORTANT
filler plug.
possible ( 2,000 H - PERIODIC SERVICE).
COMMAND AND CONTROL INSTRUMENTS).
LUBRICANTS AND FUEL).
LUBRICANTS AND FUEL), filtered through a
IMPORTANT
Never refill while engine is running.
IMPORTANT
IMPORTANT
Do not use a high pressure cleaner or water jet.
Take precautions with electrical and electronic components.

Coolant level

Fuel level

Cyclonic pre-filter (option)

Driver's cab

3 - 13
www.duma-rent.com
2
1
1
2
1
2