Emergency Stop; Accelerator Pedal; Brake And Transmission Cut-Off Pedal; Forward/Neutral/Reverse Gear Selection - Manitou MC 25-2 D K ST3A S1 Operator's Manual

9 - EMERGENCY STOP

- Press button 1 to stop the lift truck.
- Turn the button to unlock the emergency stop.

10 - ACCELERATOR PEDAL

11 - BRAKE AND TRANSMISSION CUT-OFF PEDAL

This pedal operates in two steps:
• 1 - Press the pedal gradually to cut off the transmission and slow the lift truck.
• 2 - Continue to press the pedal gradually to brake and stop the lift truck.

12 - FORWARD/NEUTRAL/REVERSE GEAR SELECTION

When changing the direction of travel, the lift truck should be travelling at slow speed
and not accelerating.
To start the lift truck, the switch must be in neutral.
A - FORWARD GEAR
- Press the front of the switch.
B - REVERSE GEAR
- Press the back of the switch, the buzzer warns that the truck is reversing, as do
optional reversing lights.
C - NEUTRAL
- Lightly press the front or back of the switch.
SAFETY FOR MOVING THE LIFT TRUCK
Movement of the lift truck is only authorised if the operator is present.
To move the lift truck, the following sequence must be observed:
• 1 - Sit correctly in the driver's seat,
• 2 - Fasten the seat belt,
• 3 - Release the parking brake,
• 4 - Engage forward or reverse gear.
To stop the lift truck, the following sequence must be observed:
• 1 - Put the gear lever in neutral,
• 2 - Engage the parking brake,
• 3 - Remove the seat belt,
• 4 - Get out of the lift truck.
If the operator leaves the driver's cab with forward or reverse gear in operation:
- The alarm sounds continuously, the operator may sit back in the seat and continue moving.
- If the alarm sounds discontinuously, the operator must sit back in the seat and reset the forward/reverse selector to
neutral before continuing to move.
NOTE: As an option, a safety device on the seat belt fastener prevents movement. A beep signals it is in operation.
AUSTRALIAN SPECIFICATION
If the operator leaves the driver's cab with forward or reverse gear in operation:
- If the alarm sounds continuously, the operator may sit back in the seat and continue moving.
- If the alarm sounds discontinuously, the operator must, before continuing to move:
• 1 - Reset the forward/reverse selector to neutral,
• 2 - Sit down correctly in the driver's seat,
• 3 - Fasten the safety belt,
• 4 - Release the parking brake,
• 5 - Engage forward or reverse gear.
2-35
www.duma-rent.com
1
A
B
C