The Site; The Operator; The Lift Truck; Instructions To The Company Manager - Manitou MC 25-2 D K ST3A S1 Operator's Manual

Hide thumbs Also See for MC 25-2 D K ST3A S1:
Table of Contents

Advertisement

INSTRUCTIONS TO THE COMPANY MANAGER

THE SITE

- Proper management of the lift truck's area of travel will reduce the risk of accidents:
• Ground not unnecessarily uneven or obstructed,
• No excessive slopes,
• Pedestrian traffic controlled, etc.

THE OPERATOR

- Only qualified, authorised personnel can use the lift truck. This authorisation is given in writing by the appropriate person
in the establishment with respect to the use of lift trucks and must be carried permanently by the operator.
Experience has shown that there are a number of inappropriate ways in which the lift truck might be used. Such foreseeable misuse, of which the main examples are listed
-The foreseeable abnormal behaviour resulting from ordinary negligence, but not from any intentional misuse of the machinery.
- The reflex reactions of a person in the event of a malfunction, incident, fault, etc. during operation of the lift truck.
- For certain machines, the foreseeable behaviour of such persons as: apprentices, teenagers, handicapped persons, trainees tempted to drive a lift truck, operators
tempted to operate the machine to win a bet, in competition or for their own personal experience.
The person in charge of the equipment must take these criteria into account when assessing whether or not a person will make a suitable driver.

THE LIFT TRUCK

A - THE TRUCK'S SUITABILITY FOR THE JOB

- MANITOU has ensured that this lift truck is suitable for use under the standard operating conditions defined in this
operator's manual, with a STATIC TEST COEFFICIENT OF 1.33 and a DYNAMIC TEST COEFFICIENT OF 1, as specified in
harmonised standard ISO 3691-1 for mast trucks.
- Before commissioning, the company manager must make sure that the lift truck is appropriate for the work to be done,
and perform certain tests (in accordance with current legislation).

B - ADAPTATION OF THE LIFT TRUCK TO STANDARD ENVIRONMENTAL CONDITIONS

- In addition to series equipment mounted on your lift truck, many options are available, such as: road lighting, stop lights,
revolving light, reverse lights, reverse buzzer alarm, front light, rear light, etc.
- The operator must take into account the operating conditions to specify the lift truck's signalling and lighting equipment.
Contact your dealer.
- Take into account climatic and atmospheric conditions of the site of use.
• Protection against frost (
• Adaptation of lubricants (ask your dealer for information).
• Engine filtration (
For operation under average climatic conditions, i.e.: between -15 °C and 35 °C, correct levels of lubricants in all the circuits are checked in production.
For operation under more severe climatic conditions, before starting up, it is necessary to drain all the circuits, then ensure correct levels of lubricants using lubricants
- Preventing fire risks associated with use in dusty and flammable conditions (e.g. straw, flour, sawdust, organic waste, etc.).
- A lift truck operating in an area without fire extinguishing equipment must be equipped with an individual extinguisher.
There are solutions, consult your dealer.
Your lift truck is designed for outdoor use under normal atmospheric conditions and indoor use in suitably aerated and ventilated premises.
It is forbidden to use the lift truck in areas where there is a risk of fire or potential explosion (e.g. Refineries, fuel or gas depots, stores of flammable products, etc.).
below, is strictly forbidden.
- Behaviour resulting from application of the "principle of least effort" when performing a task.
3 - MAINTENANCE).
3 - MAINTENANCE).
properly suited to the relevant ambient temperatures.
The same applies to the cooling liquid.
Special equipment is available for use in such areas (ask your dealer for information).
IMPORTANT
IMPORTANT
IMPORTANT
1 - 6
www.duma-rent.com

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mc 25-4 d k st3a s1Mc 30-2 d k st3a s1Mc 30-4 d k st3a s1Msi 25 d k st3a s5Msi 30 d k st3a s5Msi 35 d k st3a s5

Table of Contents