Engine Oil Filter; Replace - Manitou MC 25-2 D K ST3A S1 Operator's Manual

MAST
• 5 - Articulation axles at the foot of the mast (2 lubricators).
• 6 - Tilt cylinder foot axles (2 lubricators).
• 7 - Tilt cylinder head axles (2 lubricators).

REPLACE

REPLACE
** Only perform for the first 50 hours of service and then every 500 hours of service or 1 year.
Dispose of the drain oil in an ecological manner.
- Place the lift truck on level ground, let the engine run at idle for a few minutes,
then stop the engine.
- Open the engine cover (
- Remove the access panel 1.
- Clean the areas around the plugs and oil filter.
DRAINING THE OIL
- Place a container under drain port 2 and unscrew the plug.
- Remove the filler plug 3 to ensure that the oil is drained properly.
REPLACEMENT OF THE FILTER
- Unscrew and discard the engine oil filter 4, together with its seal.
- Clean the filter bracket with a clean, lint-free cloth.
- Lightly lubricate the seal before refitting the new oil filter (
AND BELTS) on its support (tightening torque 15 to 17 Nm).
FILLING WITH OIL
- Refit and tighten the drain plug 2 (tightening torque 30 to 40 N.m).
- Fill up with oil ( LUBRICANTS AND FUEL) through filler port 5.
- Wait a few minutes to allow the oil to flow into the sump.
- Start the engine and let it run for a few minutes.
- Check for possible leaks from the drain plug and the oil filter.
- Stop the engine; wait a few minutes
- Check the correct level between the two notches on dipstick 6.
- Top up if necessary.
IMPORTANT
COMMAND AND CONTROL INSTRUMENTS).
3 - 19
Engine oil **

Engine oil filter **

FILTERING ELEMENTS
www.duma-rent.com
6
7
5
1
2
3
5
4
6