Manitou MC 25-2 D K ST3A S1 Operator's Manual page 108

CHECK
CHECK
CHECK
CLEAN
CLEANING CONDENSER AND EVAPORATOR COILS
CLEANING CONDENSATE TRAY AND RELIEF VALVE
COLLECTING COOLANT TO REPLACE DRIER FILTER
REFILLING WITH COOLANT AND CHECKING THE THERMOSTATIC CONTROL AND PRESSURE SWITCHES
NOTE: When opening the evaporator unit, remember to replace the cover seal.
DO NOT ATTEMPT TO REPAIR ANY PROBLEMS YOURSELF. ALWAYS REFER TO YOUR DEALER WHEN REFILLING CIRCUITS, AS THEY HOLD THE CORRECT SPARE PARTS, AS
If inhaled, take the victim to fresh air.
If there is contact with the skin, wash immediately with plenty of water .
If there is frostbite, apply a sterile dressing.
If there is contact with the eyes, rinse with clear water for 15 minutes.
IMPORTANT INFORMATION REGARDING THE COOLANT USED
• This product contains fluorinated greenhouse gases covered by the Kyoto Protocol.
• Coolant type: R134A; it is colourless and odourless and heavier than air. Its GWP (Global Warming Potential) is 1430.
• Do not allow the gas to escape into the atmosphere. Do not open the circuit under any circumstances, as this could
cause coolant to escape.
- The compressor has a fluid level gauge; never unscrew this gauge because it would
depressurise the system. The fluid level should only be checked when draining
the system.
CLEAN/CHECK
Hydraulic circuit pressures *
Hydraulic circuit flow rates *
Bearings and bushings *
Air conditioning (OPTION) *
IMPORTANT
WELL AS HAVING THE NECESSARY TECHNICAL KNOWLEDGE AND TOOLS.
In any of the following circumstances, call a doctor.
Hydraulic oil tank and strainer *
3 - 32
www.duma-rent.com
* Consult your dealer.