Fuel Filter - Manitou MC 25-2 D K ST3A S1 Operator's Manual

REPLACE
- Switch off the lift truck's ignition.
- Open the engine cover (
- Carefully clean the outside of the filter and its holder, to prevent dust from getting
into the system.
- Close the filter tap 1 in the OFF position.
- Unscrew the retaining ring 2, remove the housing 3 and clean the inside using a
brush immersed in clean diesel oil.
- Remove and discard the filter cartridge 4.
- Clean the inside of the filter head using a brush immersed in clean diesel oil.
- Refit a filter and a new seal lubricated with clean diesel beforehand (
CARTRIDGES AND BELTS).
- Tighten the ring by hand pressure only and lock with a quarter turn
- Open the filter tap 1 in the ON position.
REPLACE
After replacing the fuel filter, replace the fuel pre-filter.
- Carefully clean the outside of the filter and its holder, to prevent dust from getting
into the system.
- Close the filter tap 1 in the OFF position.
- Unscrew the retaining ring 2, remove the housing 3 and clean the inside using a
brush immersed in clean diesel oil.
- Remove and discard the filter cartridge 4.
- Clean the inside of the filter head using a brush immersed in clean diesel oil.
- Refit a filter and a new seal lubricated with clean diesel beforehand (
CARTRIDGES AND BELTS).
- Tighten the ring by hand pressure only and lock with a quarter turn
- Open the filter tap 1 in the ON position.
- Bleed the fuel supply circuit (
COMMAND AND CONTROL INSTRUMENTS).
OCCASIONAL SERVICE).
3 - 22
www.duma-rent.com

Fuel filter

1
FILTER
Fuel pre-filter
FILTER
4
3
2
1
4
3
2