Table of Contents
Advertisement
[B]
NIC board (GF-1150)
(1)
Take off the SYS board lower cover and SYS
board upper cover
(
P.2-34 "[A] Hard disk (HDD)").
(2)
Release 2 locking supports, remove 2
screws, and then take off the NIC board.
Note:
NIC board is available as an option (GF-
1150) for some destinations or versions.
[C] System control PC board (SYS board)
(1)
Take off the SYS board upper cover and SYS
board lower cover
(
P.2-34 "[A] Hard disk (HDD)").
(2)
Take off the NIC board
(
P.2-36 "[B] NIC board (GF-1150)").
(3)
Disconnect 4 connectors, remove 8 screws,
and then take off the SYS board.
[D] SYS board case
(1)
Take off the SYS board upper cover and SYS
board lower cover
(
P.2-34 "[A] Hard disk (HDD)").
(2)
Disconnect 4 connectors and release the
harness from 3 harness clamps.
e-STUDIO200L/230/280 OUTLINE OF THE MACHINE
NIC board
SYS board
Screw
2 - 36
04/09
Fig.2-45
Screw
Screw
Fig.2-46
Harness clamp
Harness clamp
Fig.2-47
June 2004 © TOSHIBA TEC
Advertisement
Table of Contents
