Toshiba e-STUDIO200L/230/280 SERIES Service Manual page 286

[C] Paper exit drive unit
(1) Take off the paper exit unit
( P.14-5 "[B] Paper exit unit").
(2) Release the harness from 2 harness clamps.
(3) Remove 3 screws and take off the paper exit
drive unit.
(4) Remove 3 gears and take off the timing belt.
And then slide the exit motor to the hole and
take it off.
[D] Exit sensor
(1) Take off the paper exit unit
( P.14-5 "[B] Paper exit unit").
(2) Disconnect 1 connector and take off the exit
sensor.
e-STUDIO200L/230/280 PAPER EXIT SECTION
Drive unit
Harness
clamp
Gear
Timing belt
Gear
14 - 6
Harness
clamp
Fig.14-6
Gear
Exit motor
Fig.14-7
Exit sensor
Fig.14-8
June 2004 © TOSHIBA TEC