Table of Contents
Advertisement
13.5 Disassembly and Replacement
[A]
Fuser unit
(1)
Take off the right rear cover
(
P.2-32 "[N] Right rear cover").
(2)
Disconnect 2 connectors, remove 2 screws,
and then take off the fuser unit.
Notes:
1. Be careful when handling the fuser unit as
it may become very hot.
2. Be careful not to hold the center part
(shaded part in the figure at right).
[B]
Fuser unit upper cover
(1)
Take off the fuser unit
(
P.13-11 "[A] Fuser unit").
(2)
Release the harness from the harness
clamp. Remove 4 screws and take off the
fuser unit upper cover.
June 2004 © TOSHIBA TEC
Fuser unit
Fig.13-7
Fig.13-8
Fuser unit upper cover
Fig.13-9
13 - 11
Connector
Connector
e-STUDIO200L/230/280 FUSER UNIT
13
Advertisement
Table of Contents
